THOMSON MEC 310#GENSET CONTROLLER - Page 42

MEC 310 GENSET CONTROLLER
PM075 REV 2 09/08/20 Page 38 THOMSON TECHNOLOGY
4. Under the Parameters tab of the TPS300 Software the user will need to setup all of the
required Channels that will need to be associated to the Common Alarm or Common
Shutdown relays.
Example Parameter Settings:
•
Setup parameter with required ‘Setpoints’
and ‘Timer’ values.
•
Set ‘Fail class’ to WARNING or SHUTDOWN.
•
Leave ‘Output A’ and ‘Output B’ to NOT
USED.
•
ENABLE to parameter settings.