Thor Kitchen internal use only
Component Access
Removing outer door skin
1. Remove door from range.
2. Remove the door handle and handle
holders from the door.
3. Remove the two screws going thru the
door to the handle holder studs
Note it may be necessary to hold the
door handle stud with pilers or similar
when removing the screw.
4. Remove the 3 screws along the bottom
of the door
5. Holding the two-door half together flip
the oven door over so the Stainless-steel
door is now facing up.
6. Lift the stainless-steel door skin up and
free from the inner door.
Replacing outer door glass
1. Remove the stainless-steel door skin
from the door ( see steps above)
2. Remove the two nuts securing the THOR
logo
3. Remove support bracket at bottom edge
of glass. Glass is held to door with
double sided tape, use a heat gun to
warm the edges of the glass to make
tape removal easier, use a putty knife or
similar instrument to aid in separating
glass from the door. Secure new glass
to door skin with double sided tape and
install the support bracket and logo nuts.
Fig.01
Fig.02
Fig.03
To Next Page
Loading...
