THORLABS DCC1645C Description And Sdk Manual

© 2016 Thorlabs Scientific Imaging
4 Programming (SDK)
335
4.3.78 is_SetCameraID
USB 2.0
USB 3.0
USB 2.0
USB 3.0
Syntax
INT is_SetCameraID (HIDS hCam, INT nID)
Description
Using is_SetCameraID(), you can assign a unique camera ID to a camera. Thus, it is possible to
access the camera directly with the is_InitCamera() function.
The camera ID is stored in the non-volatile memory of the camera. The factory default camera ID is
1. The camera ID can also be changed in the uc480 Camera Manager.
Input parameters
hCam
Camera handle
nID
1...254
New camera ID
IS_GET_CAMERA_ID
Returns the current ID.
Return values
When used together with
IS_GET_CAMERA_ID
Current ID
IS_ACCESS_VIOLATION
An internal error has occured.
The camera ID cannot be changed because the
camera is running in the boot-boost mode.
IS_CANT_COMMUNICATE_WITH_DRIVER
Communication with the driver failed because
no driver has been loaded.
IS_CANT_OPEN_DEVICE
An attempt to initialize or select the camera
failed (no camera connected or initialization
error).
IS_INVALID_CAMERA_TYPE
The camera type defined in the .ini file does not
match the current camera model.
IS_INVALID_CAMERA_HANDLE
Invalid camera handle
IS_INVALID_MODE
Camera is in standby mode, function not allowed
IS_INVALID_PARAMETER
One of the submitted parameters is outside the
valid range or is not supported for this sensor or
is not available in this mode.
IS_IO_REQUEST_FAILED
An IO request from the uc480 driver failed.
Possibly the versions of the uc480.dll (API) and
the driver file (uc480_usb.sys) do not match.
IS_NO_SUCCESS
General error message
IS_NOT_CALIBRATED
The camera does not contain any calibration
data.
IS_NOT_SUPPORTED
The camera model used here does not support

THORLABS DCC1645C Specifications

General

Brand	THORLABS
Model	DCC1645C
Category	Security Camera
Language	English