© 2016 Thorlabs Scientific Imaging430
DCx Camera Functional Description and SDK Manual
The image memory is already included in
the sequence and cannot be added again.
IS_SEQUENCE_BUF_ALREADY_LOCKED
The memory could not be locked. The
pointer to the buffer is invalid.
The device ID is invalid. Valid IDs start from
1 for USB cameras, and from 1001 for GigE
cameras.
The board ID is invalid. Valid IDs range from
1 through 255.
A timeout occurred. An image capturing
process could not be terminated within the
allowable period.
One of the submitted parameters is outside
the valid range or is not supported for this
sensor or is not available in this mode.
No memory could be allocated.
An internal error has occured.
The camera is connected to a port which
does not support the USB 2.0 high-speed
standard.
Cameras without a memory board cannot be
operated on a USB 1.1 port.
A capturing operation is in progress and
must be terminated before you can start
another one.
The requested image is not available in the
camera memory or is no longer valid.
The function cannot be used because the
camera is waiting for a trigger signal.
A CRC error-correction problem occurred
while reading the settings.
This function has not been enabled yet in this
version.
The camera does not contain any calibration
data.
The system is waiting for the kernel driver to
respond.
The camera model used here does not
support this function or setting.
The function is not possible as trigger is
disabled.
The dialog was canceled without a selection
so that no file could be saved.