Use the is_ImageFile() function to save the current image as a BMP or JPEG file. To
save a specific image, it is better to use the Snap function (single frame mode) than the
Live function (continuous mode).
See also:
How to proceed: Saving images and videos
When you want to exit your application, close the camera with is_ExitCamera(). The
camera and the allocated memory are automatically released. All previously set camera
parameters will be lost, however. So, if you want to save specific settings, use the
is_ParameterSet() function before closing the camera. The next time you start the
application, you can simply load the settings again by using the same function.
To Next Page
Loading...
Need help?
General
