TIMYO kreutzer E-pack - Headlight; Rear Light; Walk Assist; Maintenance; Battery Capacity Indicator

© TIMYO B.V. TIMYO USER MANUAL EN SKO52021V2 PAGE 31
MANUAL VANDIJCK E-BIKES VD0.1
5.3.5 Headlight / Rear light
Press and hold for more than 2 seconds to turn on the headlight and rear light.
Press and hold again for more than 2 seconds to turn the headlight off. The brightness
of the rear light can be set in the 'Brightness' settings.
5.3.6 Walk assist
To activate the walk assist: Press until this symbol
appears. Then press and hold while the symbol
is displayed. Walking assistance is now activated. The symbol will
flash and the e-bike will move at a speed of approx. 5 km/h. When
you let go, the engine will automatically stop and the assist level will
automatically return to level 0.
Please note: you cannot use the walk assist while cycling!
5.3.7 Maintenance
The display will show the message 'Service' once a certain number of kilometres have been covered.
At a mileage of more than 5,000 km (or more than 100 charging cycles) the message 'Service' will
appear in the display. The SERVICE message will appear in the display screen after every 5,000 km.
This functionality can be set in the settings.
5.3.8 Battery Capacity Indicator
The battery capacity is shown in
the upper left hand corner of the
display. Each full dash represents
a percentage of battery capacity
remaining (as shown in the table).
!
80% - 100%
60% - 80%
40%-60%
20%-40%
5%-20%
< flashes