TIMYO kreutzer E-pack - Error Messages; Throttle; About the Throttle

© TIMYO B.V. TIMYO USER MANUAL EN SKO52021V2 PAGE 46
5.6.5 Error messages C300T
You may see an error message in the display if something goes wrong in the electronic system. The
error messages have the following codes:
Contact a technician to correct the error message. The display will not return to normal until the
problem is resolved. The drive will not be functional until then.
5.6.6 Throttle
The C300T has an additional button, this is a throttle at the bottom of the display. To get going, short-
press the throttle. This way you don't have to move the whole bike yourself.
5.6.7 About the throttle
This throttle is located under the control unit. This is in addition to walk-assist, where the engine
provides an impulse while walking.
Number Definition Solution
0
Normal Normal situation; no action required
1
Short circuit in the system / incorrect voltage Contact a technician
2
Error in pedal sensor Contact a technician
3
Problem with power supply to the engine Contact a technician
4
Defect in engine housing Contact a technician
5
Brake problem Contact a technician
6
Low voltage -> battery is empty Charge the battery
7
Engine trouble (stalls) Contact a technician
8
Communication error controller Contact a technician
9
Communication error display Contact a technician