TIMYO kreutzer E-pack - Error Codes; Error Messages

© TIMYO B.V. TIMYO USER MANUAL EN SKO52021V2 PAGE 17
MANUAL VANDIJCK E-BIKES VD0.1
5.1.3 Error codes DPC18
5.1.4 DPC18 error messages
You may see an error message in the display if something goes wrong in the electronic system. The
error messages have the following codes:
Contact a technician to correct the error message. The display will not return to normal until the
problem is resolved. The drive will not be functional until then.
Error code Definition Solution
“07”
High voltage protection Check the battery voltage
“08”
Error with engine hall sensor inside Have your dealer check the engine stator
“10”
Engine temperature has reached the
maximum protection value
Stop riding and wait until the LED stops blinking
“12”
Error with power sensor in controller Have your dealer check the sensor
“13”
Error with temperature sensor in battery Check the battery
“21”
Error with speed detection sensor Check the engine stator
“22”
BMS Communication error Replace the battery
“30”
Communication error 1. Check the connectors between the EB-BUS and
the controller
2. Replace the controller
Number Definition Solution
0
Normal Normal situation; no action required
1
Short circuit in the system / incorrect voltage Contact a technician
2
Error in pedal sensor Contact a technician
3
Problem with power supply to the engine Contact a technician
4
Defect in engine housing Contact a technician
5
Brake problem Contact a technician
6
Low voltage -> battery is empty Charge the battery
7
Engine trouble (stalls) Contact a technician
8
Communication error controller Contact a technician
9
Communication error display Contact a technician