TIMYO kreutzer E-pack - Charger and Drive Unit; Charger Operating Instructions

To Next Page

To Previous Page

7 Charger

The charger is specifically designed for charging lithium ion batteries. It features an

integrated fuse and overload protection.

7.1 Operating instructions

Please read the instructions for use of the charger and the label on the charger before use.

To minimize the risk of an electric shock, never open the charger device. Maintenance work

may only be carried out by qualified personnel. Make sure you read the information on

your battery charger before you ever charge the battery! Disconnect the charger before

removing the battery from the charger. Flammable gases may leak out.

Avoid flames and sparks.

Keep the charger away from children and animals. Small children and animals could

damage the cable if they play with it. Doing so may result in electric shock,

malfunction or fire.

■ The charger must not be used by children or persons with reduced physical,

sensory or mental capabilities, unless they are supervised by a responsible adult.

■ Make sure the charger is clean. There is a risk of electric shock.

■ Do not use the charger in damp or dusty places.

■ Avoid direct sunlight.

■ Unplug the charger when not in use.

■ Only use the charger supplied with the e-bike or one from the same manufacturer.

■ Do not cover the charger when in use. This can cause short circuits or fire.

■ Unplug the charger before cleaning it.

■ If charging takes longer than stated in the specifications table, stop charging.

■ After charging, remove the Battery pack from the charger and unplug it from the

power outlet.