TIMYO kreutzer E-pack - Page 37

© TIMYO B.V. TIMYO USER MANUAL EN SKO52021V2 PAGE 37
MANUAL VANDIJCK E-BIKES VD0.1
Number Definition Solution
25
Torque signal error. 1. Check that all connections are correctly
connected.
2. Contact your dealer if the
problem persists.
26
Speed signal from torque sensor has an
error.
1. Check the speed sensor connector
to check that it is connected correctly.
2. Check the sensor for signs of damage.
3. Contact your dealer if the
problem persists.
27
Overcurrent, electric power, from controller. Contact your dealer.
30
Communication problem. 1. Check that all connections are correctly
connected.
2. Contact your dealer if the
problem persists.
33
Braking signal has an error.
(If brake sensors are fitted)
1. Check all connectors.
2. Contact your dealer if the
problem persists.
35
Detection circuit for 15V has an error. Contact your dealer.
36
Detection circuit on the control panel has an
error
Contact your dealer.
37
WDT circuit is defective. Contact your dealer.
41
The total voltage of the battery is
too high.
Contact your dealer.
42
The total voltage of the battery is
too low.
Contact your dealer.
43
The total power of the battery cells is too
high
Contact your dealer.
44
The voltage of the single cell is too
high.
Contact your dealer.
45
The temperature of the battery is too
high.
Contact your dealer.
46
The temperature of the battery is too
low.
Contact your dealer.
47
The SOC of the battery is too high. Contact your dealer.
48
The SOC of the battery is too low. Contact your dealer.