1-3
■
■ Precautions during operation
- Do not place any container with liquid in it on the instrument. Any liquid
entering the instrument may cause electric shock or failure.
- Be sure to touch the “New” button to delete the measurement data for
the previous patient before measuring a new patient. If new
measurement is started without deleting the previous data, the
measurement data for the previous patient may be included.
- Do not allow the patient to touch the terminals for connecting the
instrument to external devices.
- When moving the measuring head and/or chin rest of the instrument,
pay attention to the position of the patient's face, hands, and fingers. The
patient may be injured by the moving section of the instrument.
- Do not allow any person to place their hands or fingers in the clearance
under the measuring head or the section under the chin rest. Their
hands or fingers may be caught and injured.
- Do not lean on the instrument or press the instrument from the top. The
instrument may topple over, resulting in mechanical failure or injuries.
- Be careful to not exceed the time and quantity limit required for
diagnosis, medical treatment, and measurement.
- Constantly observe that both the instrument and patient are free of
problems.
- If a problem with the instrument or the patient occurs, take appropriate
action, such as stopping the device, to ensure the patient’s safety.
- Do not allow the patient to touch the instrument.
- If problems such as smoke, offensive odor, or abnormal sound occur,
immediately turn off the instrument, disconnect the power plug from the
outlet, and contact Tomey Corporation or our local distributor.
■ Precautions after operation
- Do not place any container with liquid in it on the instrument. Any liquid
entering the instrument may cause electric shock or failure.
- Do not use organic solvents such as thinner, benzene, or acetone to
clean the instrument. Fire or electric shock may occur. (These solvents
may also corrode the resin or coating on the cover of the instrument.)
- Follow the specified procedures to return the operation switch, dial, etc.
to their original positions and turn the instrument off.
- Hold the plug when disconnecting the power plug from the outlet to avoid
placing excessive force on the cord. Pulling the cord may damage the
inner core wires, resulting in electric shock or fire.
- When disconnecting cords, do not apply too much force on them, for
example, do not hold and pull the cord.
- Refer to "5.6 Storing" for instructions on the storage of the instrument.
To Next Page
Loading...
