■
3-80
[Ultrasound – Pachy]
(Fig. 1) (Fig. 2)
(1) Data Selection Method
Select the measurement data type to be displayed.
Latest / Minimum / Average
(2) Measure Point
Opens the measurement setup screen (Fig. 2).
(3) PreSet1 / PreSet2
Changes the selected preset measurement point.
(4) Eye selection
Changes the preset measurement point of the selected eye.
(5) Radius input field
Specify the radius distance from the center of the measurement point. Touch
the input field. The keypad appears. Touch the “▼” on the right of the input field
The pull down menu appears. Select CCT or enter the desired value using the
keypad.
Input range : 0.1 - 15.0 mm
(6) Angle input field
Enter the angle from the horizontal axis at the measurement point. The key pad
appears when the input field is touched.
Input range : 0 – 179
(7) S/I selection button
The mode alternates between “S” and “I” every time you touch the button.
(8) “Apply Current Value" button
Enters the measurement points currently being used in each field on the
measurement screen.
(1)
(2)
(3) (4)
(5)
(6)
(7)
(4)
(8)
To Next Page
Loading...
