■
3-2
[Wireless connection]
Refer to "3.2.2 Wireless communication connection with the axial length and
corneal thickness measurement instrument AL-4000" to make settings.
c) External digital printer
■ Use only the specified printer and cables. Use a video signal cable or
remote cable to connect this instrument to a device conforming to
IEC60601-1 or JIS T 0601-1 or conforming to IEC60950-1 and with a power
source isolated by an insulated transformer.
(Fig. 1)
[Video printer]
1) Insert the cable plug A(1) of the USB-H cable into the USB connector (2) on the
side of the main unit in the correct orientation.
2) Connect the other cable plug B (3) of the USB cable to a video printer.
Follow the instruction manual of the video printer for details on how to
connect the printer.
[PictBridge printer]
1) Plug the mini cable plug B (3) of the USB cable into the mini USB-D
connector PICT (4) on the side of the main unit in the correct orientation.
2) Connect the other cable plug A (1) or mini A of the USB cable to a video
printer.
Refer to the instruction manual of the PictBridge printer for details on how to
connect the printer.
(2)
(3)
(1)
(4)
(2)
(3)
(1)
(4)
(Fig. 1)
To Next Page
Loading...
