3-3
■
d) External ID input device
Plug the connector of the external ID input device (e.g. barcode reader, card
reader, keypad, and keyboard) into the USB-H terminal (1) on the side of the
main unit, checking the correct orientation.
e) Connecting OKULIX USB dongle
■ Use the OKULIX USB dongle specialized for this instrument included in
the package.
■ Connect the OKULIX USB dongle directly to the instrument without using
an USB hub.
Connect the OKULIX USB dongle to the USB-H connector terminal (1) on the side of
the instrument.
f) Connecting the personal computer
■ The network support system “TOMEY Link” (optional) or the inspection
data receiving software “DATA Transfer” (included in the package) is
required for data communication with the Machine.
■ Refer to the corresponding operation manual for installation, settings,
and operation of TOMEY Link and DATA Transfer.
■ Connection setting is required for connecting with TOMEY Link and
DATA Transfer. Refer to "3.9.4 d) PC connection settings" to make
settings.
■ Be sure to make network settings under the consent of your network
administrator.
There are two methods to connect with a personal computer: LAN connection and
USB connection.
(1)
(Fig. 1)
(Fig. 1)
(1)
To Next Page
Loading...
