3-5
■
h) Connection with Biometer AL-100
■ The following settings are required in Biometer AL-100. . Refer to the
Biometer AL-100 instruction manual for the settings.
BAUD RATE: 38400
DATA LENGTH: 8 Bit
PARITY: NONE
STOP BIT: 1 bit
Use a serial cable (Dsub 9 pins, crossover cable, male + female) and USB serial
conversion cable for connection.
1) Connect the serial cable and USB serial conversion cable.
2) Insert the USB plug into any of the USB-H connectors (1) on the side of the main
unit, and insert the serial cable plug into the Communication Cable Terminal (2)
on the back of AL-100.
(Fig. 1 Side of OA-2000) (Fig. 2 Back of AL-100)
(1)
(2)
To Next Page
Loading...
