■
3-22
d) Selecting specific measurement data to be used for calculating IOL power
The average value is normally adopted for the measurement data to be used in
calculating the IOL power, but specific measurement data can also be selected.
(Fig. 1)
1) Use the selection cursor movement buttons (1) to move the selection cursor
(2) to the measurement data which is to be used in calculating the IOL power.
To use the average value in IOL power calculation, move the selection cursor
(2) to the average data.
2) When the “Select” button (3) is touched, it is selected as the data to be used
in calculating the IOL power, and a “*” appears on the left of the data.
(1)
(2)
(3)
To Next Page
Loading...
