3-35
■
1) Touch the “Delete” button (1) to delete the data selected with the cursor and
the data color changes to gray. The data deleted here is excluded from the
average.
2) To recover the deleted data, move the cursor to the data. Touch the “Recall”
button (2) to cancel deletion.
However, once the screen returns to the measurement screen, the deleted
data cannot be restored by the “Return” button even when the screen is
switched to the edit screen again.
c) Gate change function
(Fig. 1)
1) Use the selection cursor movement buttons (1) to move the selection cursor
(2) to the data to be changed. Touch the “Gate” button (3) to open the gate
change screen (Fig. 2).
(Fig. 2)
2) Touch the gate cursor selection buttons (4) to select the gate cursor to be
changed. The selected and active gate cursor is displayed in red but the
other cursors are displayed in white.
3) Touch the “gate cursor movement” buttons (5) to change the position of active
gate cursor. The changed measurement data is displayed in the edit data display
field (6) along with the movement of the gate cursor.
4) If you have edited it mistakenly, touch the “Initial Position” button (7) to cancel the
changes made, and the gate cursor will return to the position before the editing.
5) When you touch the “Apply” button (8), the changes made are applied, the
measurement data displayed in the measurement data display field (10) is
overwritten with the edited measurement data, and the gate change screen is
closed. If the “Cancel” button (9) is touched, the changes made are
discarded and the gate change screen is closed.
(6)
(7)
(10)
(4)
(5)
(8)
(9)
(2)
(1)
(3)
To Next Page
Loading...
