■
3-36
d) Caliper function
■ Values measured and displayed using the caliper function are rough
estimates and may differ from the actual measurement result.
This function is used to measure the distance of the measurement waveform.
Three dotted caliper lines (four lines in immersion mode) appear and the distance
to the selected caliper line is displayed.
(Fig. 1)
1) Use the selection cursor movement buttons (1) to move the selection cursor
(2) to the data to be measured. Touch the “Caliper” button (3) to open the
caliper screen (Fig. 2).
(Fig. 2)
2) Touch the “Switch” button (4) of the active caliper line to select the caliper line
to be changed. The selected caliper line is displayed in red but the other lines
are displayed in yellow.
3) Touch the caliper line movement buttons (5) to change the active caliper line
position. The changed measurement data is displayed in the edit data display
field (6) along with the movement of the caliper line.
4) If you have edited it mistakenly, touch the “Initial Position” button (7) to cancel the
changes made, and the caliper line will return to the position before the editing.
5) When you touch the “Apply” button (8), the changes made are applied, the
measurement data displayed in the edit data display field (6) is overwritten
with the measurement data specified by the cursor (2), and the caliper screen
is closed. Touching the “Cancel” button (9) will discard the changes made,
and the caliper screen is closed.
(2)
(1)
(3)
(6)
(7)
(8) (9)
(10)
(4) (5)
To Next Page
Loading...
