1-1
1. PRIOR TO USE
Read this manual thoroughly before using the
instrument to ensure proper and safe operation.
Always follow the operation procedures described in
this manual.
Check that there are no devices that generate a strong
magnetic eld near the instrument. A strong magnetic
eld may cause noise and affect operations including
measurement.
1.1 Precautions for operation
Only allow qualied operators to use the instrument.
Precautions when installing the instrument
Install the instrument in a location free of water or chemicals. Any water or
chemicals entering the instrument may cause an electric shock or failure.
Do not install the instrument in a location where chemicals are stored or gases
may occur. Spilt chemicals or vapor may enter the instrument and result in re.
Check the frequency, voltage, and allowable current (or power consumption) of
the power source. Otherwise, re or electric shock may occur.
Connect the power plug to a grounded 3-pin outlet. Otherwise, a short circuit
due to failure of the instrument may result in electric shock.
Do not place any heavy object on the power cord or squash the power cord.
Fire or electric shock may occur.
Fully insert the power plug into the outlet. Faulty contact, allowing any metal to
contact the exposed terminals of the plug, or dust accumulated on the exposed
terminals of the plug may result in re or electric shock.
Conduct grounding work correctly. Otherwise, you may get an electric shock.
If there is any source of noise (devices including a motor, laser surgical
equipment, etc.) near the instrument, place it as far away from the instrument
as possible. Otherwise, the instrument may malfunction.
To Next Page
Loading...
