Tomey TMS-5 - Page 199

6-5
5
Message Slit Camera Error
Contents The camera that captures cross sections for slit mode is not operating.
Solution Turn off the main unit, then turn it on again and check the condition. This
error may be solved by turning power off and then on again.
If the same message appears again, the instrument may be faulty. Stop
using the instrument and contact our local distributor.
6
Message Alignment Detection Error
Contents Displacement amount of alignment cannot be detected in slit mode.
Solution Turn off the main unit, then turn it on again and check the condition. This
error may be solved by turning power off and then on again.
If the same message appears again, the instrument may be faulty. Stop
using the instrument and contact our local distributor.
7
Message Touch Panel Error
Contents The touch panel for the screen of the main unit is not operating.
Solution Turn off the main unit, then turn it on again and check the condition. This
error may be solved by turning power off and then on again.
If the same message appears again, the instrument may be faulty. Stop
using the instrument and contact our local distributor.
8
Message Joystick Error
Contents Electrical functions of the joystick are not running.
Solution Turn off the main unit, then turn it on again and check the condition. This
error may be solved by turning power off and then on again.
If the same message appears again, the instrument may be faulty. Stop
using the instrument and contact our local distributor.
9
Message Chinrest Error
Contents The electric function that moves the chin rest up and down is not running.
Solution (1) This message also appears when excessive force is applied to the chin
rest and the chin rest cannot move up and down. Check that excessive
force is not applied to the chin rest.
(2) Turn off the main unit, then turn it on again and check the condition. This
error may be solved by turning power off and then on again.
If the same message appears again, the instrument may be faulty. Stop
using the instrument and contact our local distributor.
10 Message Alignment Motor Error
Contents The electric function that moves the head up and down is not running.
Solution Turn off the main unit, then turn it on again and check the condition. This
error may be solved by turning power off and then on again.
If the same message appears again, the instrument may be faulty. Stop
using the instrument and contact our local distributor.