2-4
(5) Up/down ring
Moves the head up and down. Moving the ring up and down moves the head for rough
positioning.
Turning the ring moves the head for ne positioning.
(6) Measurement section stopper
Lock to x the main unit when moving and/or transporting it
(7) Eye level mark
Adjust the height of the chin rest so that the patient's eyes are aligned with this mark.
(8) Membrane button panel
Performs various settings and operations.
(9) AS/MS button
Switches whether to start capturing in automatic mode or manual mode.
(10) MODE button
Switches the capture mode.
(11) PACKING button
Pressing this button for 3 seconds moves the head to the lowest position in preparation for
packing (lower dead center).
(12) CHIN REST button
Pressing the UP and DOWN buttons moves the chin rest up and down respectively.
(13) Power lamp
Stays lit green when the unit is turned on.
(14) USB connector
Connector for connecting the main unit and personal computer. Do not connect any other
peripheral devices here.
(15) Maintenance switch
Our service personnel use this switch for maintenance. Do not change the setting.
To Next Page
Loading...
