Topcon HiPer Ga User Manual

Configuring the Receiver
P/N 7010-0816
3-13
• GPS/GLO at one time – enable
• Antenna position – enter Lat, Lon, and Alt values using one
of the following methods:
– If known, type in the values.
– Enable Averaged, and enter the Averaged Span in
seconds, and then click Apply. Click ToolsReset
receiver, and wait until the specified interval (span)
completes. Examine the Base coordinates on the Base
tab; they should correspond to the coordinates obtained
from the average. Click Refresh if the coordinates are
zeros.
– Click Get from receiver.
Figure 3-10. Base Configuration
10. For the Rover receiver, click the Rover tab and set the following
parameters, then click Apply (Figure 3-11 on page 3-14).
• Positioning Mode – For post-processed surveys, select
Standalone; for RTK surveys, select RTK float or RTK fixed.
NOTICE
The reference geodetic coordinates specified on this
tab relate to the antenna L1 phase center.

Topcon HiPer Ga Specifications

General

Brand	Topcon
Model	HiPer Ga
Category	Receiver
Language	English