EasyManuals Logo

Topcon HiPer Ga User Manual

Topcon HiPer Ga
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
Pre-survey Preparation
HiPer Ga/Gb Operator’s Manual
2-14
To connect the receiver to an auxiliary battery, use an SAE
extension cable and the alligator clips cable:
1. Connect the alligator clips cable to a 12-volt battery and to the
SAE-to-SAE extension cable.
2. Connect the SAE-to-SAE extension cable to the receiver power
cable.
3. Plug the receiver power cable into the receiver’s power port.
Turning On/Off the Receiver
To turn ON the receiver, press and hold the power button until the
LEDs briefly flash.
To turn OFF the receiver, press and hold the Power button for more
than one and less than four seconds (until both the STAT and the REC
LEDs are off). This delay (about 1 second) prevents the receiver from
being turned off by mistake.
Connecting the Receiver and a
Computer
Topcon’s PC-CDU software provides an interface for various
configuration, monitoring, and management functions for the
receiver.
To configure, manage files, or maintain the receiver, connect the
receiver and a computer using one of the following methods and start
PC-CDU:
a Bluetooth-enabled external device (computer/controller)
an RS232 cable and a computer/controller
a USB cable and a computer/controller with the TPS USB driver
installed
Once a connection between the receiver and the computer/controller
is established, you can:
configure the receiver and its components

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Topcon HiPer Ga and is the answer not in the manual?

Topcon HiPer Ga Specifications

General IconGeneral
BrandTopcon
ModelHiPer Ga
CategoryReceiver
LanguageEnglish

Related product manuals