Powering Problems
P/N 7010-0816
6-3
For modem issues:
If “Modem-TPS cannot connect to the receiver,” see page 6-13.
Powering Problems
All receivers are preset in the factory to “Auto mode” for both
batteries. To check these settings, use the following procedure:
1. Connect your receiver and computer, and run PC-CDU (see
“Connecting the Receiver and a Computer,” on page 2-14).
2. Once connected, click ConfigurationReceiver.
3. On the General tab, view the Power and Charger fields. These
fields should be set to Auto. If not, change them to Auto, and
click Apply.
The receiver does not power up
The receiver may be in Zero Power Mode.
• Press the Reset key to return to Normal Mode
The batteries may be discharged.
• Connect/attach a fully charged battery and retry. See
“Powering the Receiver with an External Battery,” on page 2-
13.
• Charge the batteries overnight. See “Powering the Receiver
with an External Battery,” on page 2-13.
If using an external power source, the cable may be
disconnected or damaged.
Check that the cable is securely connected and undamaged.
The receiver may have a defective charger or defective
batteries.
TIP
Clearing the NVRAM returns the receiver to Auto
power mode (see “Clearing the NVRAM,” on
page 5-13).
To Next Page
Loading...
Need help?
General
