Configuring the Radio Modem
P/N 7010-0816
3-3
Configuring the Radio Modem
Modem-TPS is Topcon’s radio modem configuration utility for
modems embedded in Topcon receivers. Modem-TPS (version 2.2p2
or newer) provides the following functions:
• Connecting a computer to an integrated radio modem via a serial
port or Bluetooth wireless technology.
• Displaying information about the radio modem installed in the
receiver.
• Programming the radio modem’s settings.
Topcon’s configuration and surveying software, TopSURV or
Pocket-3D, also have the ability to configure Topcon receivers. Refer
to the TopSURV or Pocket-3D manuals for details.
Configuring a Digital UHF
Radio Modem
The integrated radio modem provides TX/RX UHF communications
between a Base Station and a Rover. To configure the UHF radio
modem, have the following ready:
• PC running Windows 98 or newer
• Modem-TPS 2.2p2 or newer
• A Serial cable or Bluetooth connectivity with PC
1. Connect the computer and receiver using an RS-232 cable or
Bluetooth wireless technology. Turn on the receiver.
NOTICE
When finished configuring the radio modem,
always disconnect from Modem-TPS before exiting
to prevent conflicts with serial port management.
To comply with RF exposure requirements,
maintain at least 25cm between the user and the
radio modem.
To Next Page
Loading...
