135
20. CHANGING THE SETTINGS
[HVDOUT-S] : Output distance and angle measurement results to an external device
(SET format)
[NEZOUT-S] : Output coordinates data to an external device (SET format)
[HVOUT-T] : Output angle measurement results to an external device (GTS format)
can only be allocated to 1 above)
[HVDOUT-T] : Output distance and angle measurement results to an external device
(GTS format) (can only be allocated to 1 above)
[NEZOUT-T] : Output coordinates data to an external device (GTS format) (can only
be allocated to 1 above)
[F/M] : Switch distance units between meters/feet
[HT] : Set the instrument station, coordinates and instrument height
[S-LEV] : Return signal
[TILT] : Display tilt angle
[MOTOR] : Display <Motor>
[INV] : Rotates the instrument 180°
[SRCH] : Automatically sights the center of the target
[RC] : Rotate in the direction specified by the Remote Control System
[<-RC] : Rotate in a counterclockwise direction (from the point of view of the
RC-Controller)
[RC->] : Rotate in a clockwise direction (from the point of view of the RC-
Controller)
[RC Cont] : Nullify the current measurement position and continue Turning
operation
[Fix Vel] : Fixed velocity rotation around vertical and horizontal axes
[TRK On] : Start Auto Tracking (Auto Tracking model only. [TRK Off] during Auto
Tracking)
[EDM] : EDM settings
[MENU] : Display <Menu> (coordinate measurement, setting out measurement,
offset measurement, REM measurement, missing line measurement,
resection, area calculation)
[COORD] : Coordinates measurement
[S-O] : Setting-out measurement
[OFFSET] : Offset measurement
[A-OFS] : Angle offset menu
[D-OFS] : Distance offset menu
[2D-OFS] : Offset/2D menu
[MLM] : Missing line measurement
[REM] : REM measurement
[RESEC] : Resection measurement
[AREA] : Surface area measurement
[CNFG] : Set setting out accuracy (can only be allocated to 2 and 3 above)
[H.TURN] : Rotate the instrument to the entered horizontal angle. Rotate
horizontally to the angle for the setting out point when performing
setting out (can only be allocated to 2 and 3 above).
[SHVR] : Switch distance mode between slope distance (SD)/horizontal
distance (HD)/height difference (VD)/REM (R) in setting out screens.
The capitalized letter in the softkey indicates the currently selected
mode (can only be allocated to 2 above).
To Next Page
Loading...
Need help?
General
