9. CONNECTING TO EXTERNAL DEVICES
50
PROCEDURE Connecting the instrument to a computer to transfer data from instrument in
USB mode
When connecting Windows XP, "exFat file system driver" needs to be installed to the computer.
1. Slide up the catch on the external interface hatch
to open.
2. Power OFF the instrument. Connect the USB port
2 on the instrument and computer using the USB
cable.
C "8. POWER ON/OFF"
$
• The computer does not need to be turned OFF
before connection.
3. Press the power key on the side of the instrument
while pressing {ENT} to display a message box
asking whether to boot USB mode, then press
[YES].
The screen of the instrument will be <USB Mode>.
$
• instrument may not be displayed as
<Removable Disk>. It depends on Windows
settings.
G
Follow the instructions below to ensure that the
instrument continues to operate normally during
USB transfer.
• Do not change the folder hierarchy or folder
names in <Removable Disk>.
• Do not format the "removable disk" on the
computer.
To Next Page
Loading...
Need help?
General
