51
9. CONNECTING TO EXTERNAL DEVICES
4. Perform "Safely Remove Hardware" in the
task bar and disconnect the USB cable.
5. Press the power key and hold (about 1sec) to turn
off the instrument to exit USB mode connection.
PROCEDURE Connecting the instrument to a computer to transfer data from instrument in
Mobile mode
A synchronous software needs to be installed to the computer depending on the Windows version.
1. Slide up the catch on the external interface hatch
to open.
2. Power OFF the instrument. Connect the
instrument and computer using the USB cable.
C "8. POWER ON/OFF"
$
• The computer does not need to be turned OFF
before connection.
3. Press the power key while pressing {ENT} to
display a message box asking whether to boot
USB mode, then press [NO].
The synchronous software is effective.
$
• instrument may not be displayed as
<Removable Disk>. It depends on Windows
settings.
G
Follow the instructions below to ensure that the
instrument continues to operate normally during
USB transfer.
• Do not change the folder hierarchy or folder
names in <Removable Disk>.
• Do not format the "removable disk" on the
computer.
Computer to connect Synchronous software
Windows XP ActiveSync
Windows vista/7 Windows Mobile Device Center
To Next Page
Loading...
Need help?
General
