21
ASSEMBLY PROCEDURE
FITTING THE CHINREST TISSUE
1
Remove the chinrest tissue pins.
2
Take approximately one-fifth of the pad of chinrest tissues and secure this at each end
with the pins.
FITTING THE CAP
1
Fit the cap to the shaft aligning the guide rod with the groove in the cap.
SECURING THE TONOMETER MOUNT SO-TM1 (OPTIONAL ACCESSOR
Y)
Depending on specification, SO-TM1 may be included in standard accessories.
1
Align the locating pin of SO-TM1 into the holes of the microscope, and fasten the screw.
Screw
Locating Pin
The holes
To Next Page
Loading...
