Toro 34215 - Page 29

Figure29
1.Lockingsleeve4.Drop-ratecam
2.Gatecable
5.Linkage
3.Ballstud
B.Pullthecableofftheballstud(Figure29).
C.Rotatethedrop-ratecampasttheposition9so
thattheslotinthecamisalignedwiththelinkage
(Figure29).
D.Fullypushthelinkagerearward(Figure29).
7.Allowtheremainingmaterialinthehoppertopour
intotheshallowpanandthenremovethepan.
8.Connectthehopper-gatecableasfollows:
A.Pullthelinkageoutuntilitclearsthedrop-rate
cam(Figure29).
B.Movethewide-distributionimpeller-gatelever
forward.
C.Attachingthecabletotheballstudatthegate
lever(Figure29).
9.Assembleimpellerontotheimpellershaftandsecure
theimpellerwiththedrivepin.
10.Aligntheholesinthefrontcoverwiththeclipnuts
inthechassisandsecurethecoverwiththe4thumb
nutsthatyouremovedin3.
SpreadingCharts
Note:ThecamsettingtablesforpelletmaterialandthegrassseedareprovidedwithpermissionfromtheBrinly-Hardy
Company;referencetheBrinly-HardyCompanywebsiteformoreinformation.
Thesechartsaretobeusedasanapproximateguidelineonly.Otherfactors,suchasweatherconditions,spreaderoperation,
andtheconditionofmaterial,willaffectyourresults.
CamSettingsforPelletMaterialApplication
Type
kgper93m
2
(lbper1,000ft
2
)CamSetting—OnePassCamSetting—TwoPasses
0.5(1)
3.63.1
0.9(2)
4.03.5
FinePellets
1.4(3)
4.23.7
0.9(2)
3.73.2
1.8(4)
4.74.1
MixedFinePellets
2.7(6)
5.24.5
0.9(2)
32.2
1.8(4)
4.23.7
SmallPellets
2.7(6)
4.54
29