Figure 13
1. Parking brake lever
Speed Limiter
T he speed limiter is a larg e knob located to the
right of the seat ( Figure 14 ). It allo ws y ou to set
the maxim um do wnw ard tra v el of the accelerator
pedal, thereb y limiting the maxim um r pm of the
engine . T his indirectly limits the speed of the
spra yer .
Note: T he v ehicle controls the application rate
based on y our speed and y ou do not need to k ee p
a constant speed to apply at a constant rate .
Figure 14
1. Speed limiter knob 3. Locking ring
2. Speed limiter button 4. Choke control
Choke Control
T he c hok e control is a small knob to the right
of the seat. ( Figure 14 ). T o star t a cold engine ,
pull the c hok e control up . After the engine star ts ,
regulate the c hok e to k ee p the engine r unning
smoothly . As soon as possible , push the control
do wn to the Off position. A w ar m engine requires
little or no c hoking .
Range Selector
T he rang e selector , located to the left of the seat,
has 5 positions: 3 forw ard speeds , Neutral, and
R ev erse ( Figure 15 ). T he engine will star t only
when the rang e selector is in the Neutral position.
Y ou m ust also fully press the brak e with the
spra yer stopped to c hang e rang es .
Important: Do not shift out of or change
ranges while the v ehicle is mo ving . Attempting
to change ranges while the v ehicle is mo ving
can dama ge the transmission. Onl y stopping
the spray er completel y , and full y enga ging the
brak e will safel y disenga ge the locking pin
and allo w the ranges to be changed.
Figure 15
1. Range Selector 4. Voltmeter
2. Ignition switch 5. Headlight switch
3. Hour meter
6. Neutral engine speed lock
switch
Ignition Switch
T he ignition switc h ( Figure 15 ), used to star t
and stop the engine , has 3 positions: Stop , R un,
and Star t. R otate the k ey cloc kwise to the Star t
position to star t the engine and release it to the
R un position when star ted. R otate the k ey to the
Stop position to stop the engine .
19
To Next Page
Loading...
