EasyManua.ls Logo

Toro 41177 Multi-Pro 1250 - Hour Meter; Voltmeter; Headlight Switch; Neutral Engine Speed Lock Switch

Toro 41177 Multi-Pro 1250
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hour Meter
T he hour meter ( Figure 15 ) indicates the total
n umber of hours the engine has r un. T he hour
meter star ts to function whenev er the k ey is tur ned
to the R un position.
Voltmeter
T he v oltmeter ( Figure 15 ) indicates the lev el of
c harg e in the batter y . W hen the batter y is fully
c harg ed, the v oltmeter will read in the center of
the dial when the k ey is in the R un position with
the engine off . W hen the engine is r unning the
v oltmeter needle should be to the right.
Headlight Switch
T og gle the switc h to operate the headlights
( Figure 15 ). Push it forw ard to tur n the lights on
and rearw ard to tur n them off .
Neutral Engine Speed Lock Switch
W hen the rang e selector is in the Neutral position,
y ou can use the accelerator pedal to speed up the
engine , then push this switc h forw ard to set the
engine at that speed. T his is necessar y to r un the
c hemical agitation while stationar y or operating
attac hments suc h as the hand spra yer ( Figure 15 ).
Important: T he range selector must be in
the neutral position f or the s witch to w or k.
Fuel Gauge
T he fuel g aug e is located on top of the fuel tank,
on the right side of the mac hine and sho ws the
amount of fuel in the tank.
Master Boom Switch
T he master boom switc h is located on the floor
board of the mac hine cab and to the left of the
operator . It allo ws y ou to star t or stop the spra y
operation. Press the switc h with y our foot to
enable or disable the spra y system ( Figure 16 ).
W hen the master switc h is off , the Spra y Pro
monitor screen reads “Hold."
Figure 16
1. Master boom switch
Boom Switches
T he boom switc hes are located at the front
of the control panel to the right of the seat
( Figure 17 ). T og gle eac h switc h forw ard to tur n
the cor responding boom section on and rearw ard
to tur n them off . W hen the switc h is tur ned on,
a light on the switc h illuminates . T hese switc hes
will only affect the spra y system when the master
boom switc h is on.
Figure 17
1. Boom switches, left, right
and center
5. Boom lift switch, left and
right
2. Pump switch 6. Sonic boom switch
3. Rate lockout key 7. Foam marker switch, left
and right
4. Application rate switch
20

Table of Contents

Related product manuals