Toro ProCore 648s - Setting the InfoCenter

3.Removethelynchpinthatsecuresthe
depth-stoppinandspacerstothestopbracket
(Figure119andFigure120).
g342335
Figure119
g342334
Figure120
1.Lynchpin
4.Stopbracket
2.Thinspacer—6.3mm(1/4
inch)
5.Depth-stoppin
3.Thickspacer—12.7mm
(1/2inch)
4.Positionthespacersaboveorbelowthestop
brackettoadjustthecoringdepth.
•Withallspacersatthetopofthestopbracket,
thedepthsettingis10.7cm(4-1/4inches).
•Thickspacersequateto19mm(3/4inch)
increment.
•Thinspacerequatesto9.5mm(3/8inch)
depthincrement.
Note:Youmustinstallallspacers,regardless
oftheirposition.
5.Assemblethedepth-stoppinandthespacersto
thestopbracketwiththelynchpin.
6.Repeatsteps3through5attheothersideof
themachine.
Important:Ensurethatthespacerlocation
aboveandbelowtheleftandrightstop
bracketsareidentical.
7.Installthecoring-headcover;refertoInstalling
theCoring-HeadCover(page69).
SettingtheInfoCenter
Note:Ifyouaerateinmanualmode,youmustset
theInfoCenterforthemanualgroundfollowingmode
eachtimeyoustarttheengine.
1.TurntheignitionkeytoRUNposition.
Note:Donotstarttheengine.
2.IntheInfoCenter,navigatetotheMAINMENU
(Figure121).
g358246
Figure121
3.PressthecenterInfoCenterbuttonuntilthe
SETTINGoptionisselected,andpresstheright
button.
4.PressthecenterInfoCenterbuttonuntilthe
PROTECTEDMENUSoptionisselected(Figure
122),presstherightbutton,andenteryour
4-digitpincode(e.g.1234).
54