EasyManuals Logo

Toro Z MASTER 2000 Series Service Manual

Toro Z MASTER 2000 Series
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Preface
This service manual was written expressly for T oro service technicians. The T oro Company has made
every ef fort to make the information in this manual complete and correct.
Basic shop safety knowledge and mechanical/electrical skills are assumed. The T able of Contents lists
the systems and the related topics covered in this manual.
W e are hopeful that you will nd this manual a valuable addition to your service shop. If you have any
questions or comments regarding this manual, please contact us at the following address:
The T oro Company
RLC/SWS Customer Care Department
81 1 1 L yndale A venue South
Bloomington, MN 55420
The T oro Company reserves the right to change product specications or make changes to this manual
without notice.
2000 Series Z MASTER®Service Manual Page 3 Preface
3460-328 Rev A

Table of Contents

Other manuals for Toro Z MASTER 2000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Z MASTER 2000 Series and is the answer not in the manual?

Toro Z MASTER 2000 Series Specifications

General IconGeneral
Engine Displacement726 cc
Cutting Width60 inches
Spindle MaterialCast
Drive SystemHydrostatic
SeatSuspension

Related product manuals