Engine Removal (continued)
12. Disconnect the vent hose at the engine.
Note: Cap of f the fuel lines.
13. Remove the (10 mm) nut securing the positive connector to the starter .
g420393
Figure 13
14. Using a 1/2 inch socket, remove the 5/16 inch bolt securing the engine ground
to the engine crankcase. For Briggs engines, using a 7/16 inch socket,
remove the 1/4 inch bolt securing the engine ground to the engine crankcase.
g420391
Figure 14
15. Using a oor jack, raise the rear of the machine and secure with jack stands.
2000 Series Z MASTER®Service Manual Page 4–9
Engine: Service and Repairs
3460-328 Rev A
To Next Page
Loading...
