Strata CTX Programming Guidelines
Step 3: Program CTX for First Time
1-10 Strata CTX Programming - Part 1: Getting Started 11/03
4. Trunk Assignment (300) – Choose Trunk > Basic. Set up your Trunks in the following order (see “300
Trunk Assignment” on page 6-6 for more details):
• Loop Start Trunks
• Ground Start Trunks
• T1 Trunks
• Tie lines
•FX lines
•PRI lines
• BRI lines
5. Station Assignment (200) – Choose Station > Basic. Set up your stations in the following order (see
“Assignment” on page 5-1 for more details):
• DKT Stations
• Standard Stations
• Voice Mail (VM) Ports
• Attendant Positions
• Automatic Call Distribution (ACD) Pilot DNs
•Door Phones
6. Create Station Links – Create the following groups wherever applicable and set stations to link as
necessary.
• Hunt Groups using Programs 209 and 218
• Paging Groups using Program 502
• Call Pickup Groups using Program 210
• Park Orbits using Program 102
• Paging Devices using Program 503
7. Backup Data – Choose Operation\Data Backup. Make sure the SmartMedia card is properly formatted
(see “908 SmartMedia” on page 10-4) prior to running backup. See “910 Data Backup” on page 10-13
for details.
8. Continue programming Strata CTX details.
To Next Page
Loading...
