Telephone Button Programming
300 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 11/03 13-55
Telephone Button
Programming
302-29 29 2-B channel
Transfer
)%
, n,
+ROG
n = 1. Enable
2. Disable
Enable this option to allow 2-B channel conference on PRI calls. This
allows to PRI channels to be connected in the same conference or
Tandem call.
Note This option must also be enabled by PRI provider to allow it
to work.
302-30 30 Q931 Protocol
Timer
)%
, n,
+ROG
n = 1. Normal
2. Long
Sets the Q931 Protocol Timer. If Long is set, T303 is 8s and T301 is
300s.
Table 13-27 Bearer Services Table
Bearer Services Nat’l ISDN ETSI TTC
Circuit
Mode
Speech X X X
3.1 KHz Audio X X X
7 KHz Audio X X
unrestricted digital
information
64 kbps X X X
Rate adaptation from 56
kbps
X
2x64 X X
384kbp (H0) X X X
1536kbps (H11) X X X
1920kbps (H12) X
multirate (n x 64 kbps) X
Restricted digital Information X X
Video X X
Packet
Mode
Shelf/Slot/Circuit
Table 13-28 Programs 303~315
Button Sequence Value(s) Summary
303
ISDN Trunk Delete
,
+ROG
This command deletes ISDN Trunks.
303-00 Channel Group
Number
n,
+ROG
,
+ROG
n = 1~32 (CTX100)
1~48 (CTX670 Basic)
1~128 (CTX670 Exp.)
Enter the channel group number to delete.
304
Incoming Line Group
Assignment
,
+ROG
This assignment is used to configure ILGs only, OLGs are configured
in the Outgoing Line Group Assignment 306. The same line can be
placed in an ILG and OLG.
304-00 Group Number
n,
+ROG
n = 1~32 (CTX100)
1~50 (CTX670 Basic)
1~128 (CTX670 Exp.)
Enter the group number of the line group that should be configured.
Table 13-26 Programs 300~302 (continued)
Button Sequence Value(s) Summary
To Next Page
Loading...
