System
104 System Timer
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 4-11
System
09 Dial Input Timer Permits dialed input for a telephone and trunk using DTMF.
Possible values: 0~60 sec. (default = 20)
10 Delay 1 Ringing Timer Specifies the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 12)
11 Delay 2 Ringing Timer Selects the time to wait before applying ringing to the designated phones.
Possible values: 1~60 sec. (default = 24)
12 Door Unlock Timer Select the length of time to send an electrical signal to a door for releasing the lock.
Possible values: 1~30 sec. (default = 6)
13 9+11 Judgement Timer The 9+11 Inter-digital timer provides a timing value (1~30 seconds) for the system to
wait for additional digits to be dialed looking for the 911 or 9+911 dialed codes for
treatment using the E911 procedures rather than normal dialing treatment.
Possible values: 1~30 sec. (default = 5)
14 Emergency Call Timer Sets a time for advancing the call to the next station in a list of destinations for the
call.
Possible values: 10~180 sec. (default = 30)
15 ABR Busy Detection
Time
The Destination Busy Detection timer sets the time to wait while looking for a busy
condition on an external call. If detected, it will trigger the initiation of the Automatic
Busy Redial cycle.
Possible values: 1~30 sec. (default = 5)
16 Lost Call Timer The Lost Call timer sets the time that a failed transfer recall will ring on the
originating station prior to attempting to recall a secondary location.
Possible values: 1~600 sec. (default = 180)
17 Lost Call Final Timer The Lost Call Final timer sets the time that a failed transfer recall will ring on the
secondary location before being automatically disconnected.
Possible values: 1~600 sec. (default = 30)
18 DTMF Tone Sending
Time
The DTMF tone sending duration for dialing on CO Lines.
Possible values: 80msec (default) or 160msec
19 Auto Disconnect Time after which an unsupervised trunk may be automatically released.
Possible values: 0~60 min. (default = 0)
23 System Timer Network
DSS Refresh Timer
Select Network DSS Refresh Timer (20 -180 seconds). The time interval when all
Network DSS settings are refreshed system wide.
Note DSS button LEDs change state immediately when the status of the DSS
button changes - regardless of this timer value.
Possible values: 20~180 seconds (default = 30)
24 Outgoing Number
Display Timer
This timer sets how long dialed numbers will display on telephone LCDs for outgoing
line calls. (This feature is available with CTX R2.2 or higher and CTX WinAdmin
R2.2G.0 and higher.)
Possible values:1~120 seconds (default = 10)
FIELD DESCRIPTION
To Next Page
Loading...
