e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 40
[E552] Paper remaining jam on the transport path (when the cover is closed)
Classification Error content
Other jam Paper remaining on the transport path when printing is finished
(when the cover is closed)
Step Check Item Result Measure
Next
Step
1
Jamming transport path Open the cover of the unit/area whose
picture is flashing on the control panel
and remove any paper on the transport
path.
2
Sensor in the jamming area • Sensor check (Refer to the table
below)
• Harness check
• Connector check
3
MAIN board • Harness check
• Connector check
• Board check
Notes:
If the jam is occurring in the PFU, check the board in each unit.
Parts to be replaced Remark
Sensor in the jamming area Refer to the table below.
MAIN board
Jamming area Cover Sensor Test mode/Input check
Registration area Right cover Registration sensor 03-[A]/[A]
Exit area Right cover Exit sensor 03-[A]/[B]
ADU Right cover ADU transfer sensor 03-[1]/[C]
PFU PFU side cover PFU drawer feed sensor 03-[4]/[A]
PFU PFU side cover PFU drawer feed sensor 03-[4]/[A]
PFP PFP side cover PFP upper drawer feed sensor 03-[1]/[E]
PFP upper lower feed sensor 03-[2]/[C]
To Next Page
Loading...
