2 HOW TO MAKE COPIES
26 Placing Originals
Continuous feed mode
The feeding mode is set at “continuous feed mode” by default. Once you set the originals and then press the [START]
button, they are scanned page by page continuously. It is useful when you want to copy more than one original at one
time.
1
Align all the originals.
Collate the originals in the order that you want them to be copied. The top sheet of the originals will be copied first.
When there are too many originals to be scanned at one time, divide the originals into several sets before copying.
Place the first set of the originals and then press [CONTINUE] on the touch panel while the data of this set are being
scanned. When this scanning is finished, place the next set of the originals and press the [START] button on the
control panel.
2
Place the originals with their face up and align the
side guides to the original length.
y Regardless of their sizes, originals are acceptable up to 100
sheets (35 to 80 g/m
2
(9.3 to 20 lb.)) or 16 mm (0.62") in height.
y For mixed-size originals, see the following page:
P.54 “Copying mixed-size originals in one operation”
For long originals
Pull out the original stopper so that the scanned original will not fall off.
After the original stopper was used, lift it slightly and push it in.
To Next Page
Loading...
Need help?
General
