3 BASIC COPY MODES
50 Before Using Copying Functions
Before Using Copying Functions
Default settings
This equipment is under its “default settings” when the power is turned ON, namely, if no setting change has been applied
yet, the equipment’s settings return to the default ones when the energy saving mode is cleared or the [FUNCTION
CLEAR] button on the control panel is pressed. The default settings for basic copy modes at installation are shown below.
The default settings are changeable. For details, refer to the MFP Management Guide.
Confirming the set functions
If you press [SETTINGS] on the touch panel, the menu shown below is displayed. On this menu, you can view the
functions that are currently set.
Item Default setting
Reproduction ratio 100%
Copy quantity 1
Paper selection Automatic Paper Selection (APS)
Simplex/Duplex 1-sided original -> 1-sided copy
Density adjustment Automatic adjustment
Original mode TEXT/PHOTO
Finishing mode When using the original glass:
NON-SORT NON-STAPLE
When using the RADF (Reversing Automatic Document Feeder,
optional):
SORT
Feeding mode when using the RADF (optional) Continuous feed mode
To Next Page
Loading...
Need help?
General
