1 BEFORE USING EQUIPMENT
12 Placing Paper
Unacceptable copy paper
Do not use the types of paper shown below. This could cause a paper jam.
y Damp paper
y Folded paper
y Curled or creased paper
y Paper whose surface is extremely smooth or rough
Do not use the types of paper shown below. This could cause an equipment malfunction.
y Paper whose surface has had a special treatment
y Paper once printed with other copiers or printers
Precautions for storing copy paper
Make sure of the following when storing copy paper:
y Wrap the paper in its wrapping to keep it free from dust.
y Avoid direct sunlight.
y Store in a damp-free space.
y To prevent paper from being folded or bent, store it in a flat place.
Placing paper in drawers
Follow the procedure below to place paper in a drawer. For acceptable copy paper, see the following page:
P.11 “Acceptable copy paper”
1
Turn the power of this equipment ON.
2
Pull out a drawer carefully until it comes to a stop.
3
Place paper in the drawer.
y Up to 600 sheets (64 g/m
2
) (17 lb. Bond) can be placed in one
drawer. Be sure that the height of the stacked paper does not
exceed the line indicated inside of the side guides.
P.11 “Acceptable copy paper”
y Fan and jog the stack of paper well before you place it in a
drawer, or the sheets may not be separated before being fed.
Be careful not to cut your fingers when fanning.
y Place paper with its copy side up. The copy side may be noted
on its wrapping paper.
To Next Page
Loading...
Need help?
General
