Toshiba GX9 - Page 109

GX9 ASD Installation and Operation Manual 97
OUT2 On Delay
Program Terminal Output Terminal Delays
This parameter delays the closing of the OUT2 (A & C) output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F151
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
FL On Delay
Program Terminal Output Terminal Delays
This parameter delays the closing of the FL output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F152
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT4 On Delay
Program Terminal Output Terminal Delays
This parameter delays the closing of the OUT4 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F153
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT5 On Delay
Program Terminal Output Terminal Delays
This parameter delays the closing of the OUT5 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F154
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT6 On Delay
Program Terminal Output Terminal Delays
This parameter delays the closing of the OUT6 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F155
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT7 On Delay
Program Terminal Output Terminal Delays
This parameter delays the closing of the OUT7 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
Direct Access Number — F156
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
F151 F156