Toshiba GX9 - Page 110

98 GX9 ASD Installation and Operation Manual
OUT1 OFF Delay
Program Terminal Output Terminal Delays
This parameter delays the opening of the OUT1 (A & C) output terminals by
the programmed value.
The delay may be increased to prevent relay chatter.
Direct Access Number — F160
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT2 OFF Delay
Program Terminal Output Terminal Delays
This parameter delays the opening of the OUT2 (A & C) output terminals by
the programmed value (see waveforms at F160).
The delay may be increased to prevent relay chatter.
Direct Access Number — F161
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
FL OFF Delay
Program Terminal Output Terminal Delays
This parameter delays the opening of the FL output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to prevent relay chatter.
Direct Access Number — F162
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT4 OFF Delay
Program Terminal Output Terminal Delays
This parameter delays the opening of the OUT4 output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to prevent relay chatter.
Direct Access Number — F163
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
OUT5 OFF Delay
Program Terminal Output Terminal Delays
This parameter delays the opening of the OUT5 output terminals by the
programmed value (see waveforms at F160).
The delay may be increased to prevent relay chatter.
Direct Access Number — F164
Parameter Type — Numerical
Factory Default — 2
Changeable During Run — No
Minimum — 2
Maximum — 200
Units — mS
F160 F164