GX9 ASD Installation and Operation Manual 173
Pattern Run Group 2 Selection 5
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 5 selection to be included in the Group 2 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F545
Parameter Type — Selection List
Factory Default — Preset Speed 13
Changeable During Run — No
Pattern Run Group 2 Selection 6
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 6 selection to be included in the Group 2 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F546
Parameter Type — Selection List
Factory Default — Preset Speed 14
Changeable During Run — No
Pattern Run Group 2 Selection 7
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 7 selection to be included in the Group 2 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F547
Parameter Type — Selection List
Factory Default — Preset Speed 15
Changeable During Run — No
Pattern Run Group 2 Selection 8
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 8 selection to be included in the Group 2 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F548
Parameter Type — Selection List
Factory Default — Skip
Changeable During Run — No
Pattern Run Group 3 Repeat Factor
Program Frequency Pattern Run
This parameter sets the number of times that the pattern defined in Group 3
will be run.
Direct Access Number — F550
Parameter Type — Numerical
Factory Default — 1
Changeable During Run — No
Minimum — 1
Maximum — 255 (Infinite)
Units — Repetitions
F545 F550
To Next Page
Loading...
