GX9 ASD Installation and Operation Manual 177
Pattern Run Group 4 Selection 7
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 7 selection to be included in the Group 4 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F567
Parameter Type — Selection List
Factory Default — Preset Speed 15
Changeable During Run — No
Pattern Run Group 4 Selection 8
Program Frequency Pattern Run
This parameter allows the user to select 1 of 15 configured Preset Speeds as
the number 8 selection to be included in the Group 4 Selection.
Skip may be selected to ignore this Selection.
Setting
0 — Skip
1 — 15 Preset Speed Number
Direct Access Number — F568
Parameter Type — Selection List
Factory Default — Skip
Changeable During Run — No
Preset Speed 1 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F585, this parameter is used to set the start-
time and run-time of Preset Speed 1 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F570
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
Preset Speed 2 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F586, this parameter is used to set the start-
time and run-time of Preset Speed 2 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F571
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
F567 F571
To Next Page
Loading...
