GX9 ASD Installation and Operation Manual 181
Preset Speed 15 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F599, this parameter is used to set the start-
time and run-time of Preset Speed 15 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F584
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
Preset Speed 1 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F570, this parameter is used to set the run-
time of Preset Speed 1 when used as part of a Pattern Run.
Direct Access Number — F585
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F570)
Preset Speed 2 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F571, this parameter is used to set the run-
time of Preset Speed 2 when used as part of a Pattern Run.
Direct Access Number — F586
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F571)
Preset Speed 3 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F572, this parameter is used to set the run-
time of Preset Speed 3 when used as part of a Pattern Run.
Direct Access Number — F587
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F572)
Preset Speed 4 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F573, this parameter is used to set the run-
time of Preset Speed 4 when used as part of a Pattern Run.
Direct Access Number — F588
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F573)
F584 F588
To Next Page
Loading...
