182 GX9 ASD Installation and Operation Manual
Preset Speed 5 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F574, this parameter is used to set the run-
time of Preset Speed 5 when used as part of a Pattern Run.
Direct Access Number — F589
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F574)
Preset Speed 6 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F575, this parameter is used to set the run-
time of Preset Speed 6 when used as part of a Pattern Run.
Direct Access Number — F590
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F575)
Preset Speed 7 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F576, this parameter is used to set the run-
time of Preset Speed 7 when used as part of a Pattern Run.
Direct Access Number — F591
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F577)
Preset Speed 8 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F577, this parameter is used to set the run-
time of Preset Speed 8 when used as part of a Pattern Run.
Direct Access Number — F592
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F577)
Preset Speed 9 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F578, this parameter is used to set the run-
time of Preset Speed 9 when used as part of a Pattern Run.
Direct Access Number — F593
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F578)
Preset Speed 10 Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F579, this parameter is used to set the run-
time of Preset Speed 10 when used as part of a Pattern Run.
Direct Access Number — F594
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — Yes
Minimum — 1
Maximum — 8000
Units — User Select (F579)
F589 F594
To Next Page
Loading...
