GX9 ASD Installation and Operation Manual 179
Preset Speed 7 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F591, this parameter is used to set the start-
time and run-time of Preset Speed 7 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F576
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
Preset Speed 8 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F592, this parameter is used to set the start-
time and run-time of Preset Speed 8 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F577
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
Preset Speed 9 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F593, this parameter is used to set the start-
time and run-time of Preset Speed 9 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F578
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
Preset Speed 10 Start/Run Time
Program Frequency Preset Speed Time Settings
In conjunction with the setting of F594, this parameter is used to set the start-
time and run-time of Preset Speed 10 when used as part of a Pattern Run.
Settings:
Seconds From Start
Minutes From Start
Seconds From Reach
Minutes From Reach
Infinite (Until Stop Command)
Continue Until Next Step
Direct Access Number — F579
Parameter Type — Selection List
Factory Default — Seconds From Start
Changeable During Run — No
F576 F579
To Next Page
Loading...
