エラー
!
スタイルが定義されていません。
Replacement Procedures
エラー
!
スタイルが定義されて
Installing the Camera module
To install the camera module, follow the steps below and refer to Figure 4-55.
1. Set the cushion to a new camera module.
2. Peel off the protection sheet.
NOTE: When peeling off the protection sheet, with care of the followings:
3. Connect the camera harness to the connector on the camera module and set the
camera module into the guide of the LCD cover.
4-90 [CONFIDENTIAL] QOSMIO F60 Maintenance Manual (960-796)
To Next Page
Loading...
